![]() When to Use ¼” Tapcon?Īll tapcon drill bits have to be used with hammer drills and you need to make sure the hammer drill is set into hammer and rotation mode, or it will not work properly. If you buy carbide tips that are older or cheaper in quality, you will find that the material has a lower melting point and that the brazing method will not last as long. ![]() The ANSI standard carbide tips are brazed on one end, and they ensure a much longer life and will make sure all your hole diameters are consistent. Carbide tips are also required to be used for all the hole drilling into base materials if you are using a Tapcon screw. Make sure you are getting a carbide tip that meets the ANSI Standard B212-15-1994 since these are the only official ones that can be used for masonry. The flat end should also be aligned with the flat side out so that when it’s inserted into the toolkit, a set screw can be tightened against it. The flat end is on the opposite end of the carbide tip and will be the side you insert into your installation tool kit. ![]() The flat end of your tapcon drill bit should also be located so you know where to insert the screws. Remembering all the tips above can seem difficult, but making sure you have the right drill and minimum depth is required to make sure you can make the project or home you are building correctly. You also need to remember to use the correct diameter as well that was listed above. These are the different lengths you will use to meet the minimum hold depth requirements. Below is a summary of the different lengths and what their drill depth should be: Tapcon Keep in mind that the ¼” Tapcon comes in 4 different sizes, so there are different drilling depths for each of them. If you do not use the right size, the base material can be ruined, and you might not be able to complete the project you are working on. The length you use for your tapcon is very important because it has to be long enough to ensure that the hole drilled is ½” deeper than the Tapcon screw you will be used to in the base material. A ¼” tapcon requires a 3/16” diameter drill bit for drilling.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |